VLG archive · Message 31
RE: espada dash restoration
Author: Robinson, Aaron
Message
Peter: I"m not too familiar with the S2 dash trim, but I did have to re-make the flimsy steering wheel trim ring after we destroyed it out of stupidity (details unnecessary), which I"m pretty sure was red mahogany originally. My woodworking friend and I started with a hunk of Australian lacewood, cut the inner diameter on a jig saw and then turned the out diameter on a lathe. Hours of sanding, then about 20 coats of polyurethane with four-day cure and a steel wool rub-down in between each. Point is, once it was finished it was indistinguishable from the wheel. Australian lacewood is pretty common at places that sell hardwoods, so if you"re still considering wood choices that is one. It"s not very expensive. I"ll probably be making a new steering wheel rim out of it at some point as it has some small cracks in it. Regarding chrome trim, not sure exactly what you"re looking for but consider plate-glass edging (a u-channel of chrome-finished plastic) or car-door edging available at most auto parts places. Recently replaced the chrome bead around an Alfa center console wood strip with it. It bends in one dimension but doesn"t like compound curves very much. Miami Rubber and JC Whitney also sell runs of the stuff. AR -----Original Message----- From: drakepeterdrake [mailto:drakepeterdrake@aol.com] Sent: Tuesday, November 26, 2002 5:42 PM To: VintageLambo@yahoogroups.com Subject: [VintageLambo] espada dash restoration I have a 1971 series II espada. I am going to replace the piece of wood in the center upper dash where the light and wiper switches are. I"ve been looking at veneers. The factory said the wood was mahagony, but so far the closest grain match I found to my car is teak.I bought a sheet of veneer and will experiment with different flat finishes to get the color as close as I can to what was there. The veneer I could find is not self-stick; any suggestions for gluing and technique? It"s 10 mil thick. I"m also thinking of deleting the radio opening. The car is too loud anyway. This will also entail eventually re-covering the inner door panels, where speakers were mounted.Unfortunately, the metal edging that surrounds the wood dash piece was cut away at the top of the radio opening. Does anyone know of a source for that metal trim? It may be easier to find a period radio and live with the door speakers, but I want to examine the options.
Attachments
No attachments are recorded for this message.