VLG archive · Message 26

Re: espada dash restoration

Author: miura_sv

Message

You might try a contact cement used to glue down laminate countertops.Cut the veneer slightly oversize, then apply the cement to both sides you wish to join with a brush or roller, let dry until slightly tacky, then join the two pieces, starting at one end, using a laminate roller to press out any bubbles.The stuff is very durable, unless the substrate gets wet and expands.Then trim with a router or laminate trimmer using a laminate bit and finish as desired. Check with a woodworking specialty store.They probably have something better than the home improvement stores.They would have a better veneer selection as well.Good luck, and post us some photos. Udo --- In VintageLambo@y..., "drakepeterdrake" wrote: > I have a 1971 series II espada. I am going to replace the piece of wood > in the center upper dash where the light and wiper switches are. I"ve > been looking at veneers.

Attachments

No attachments are recorded for this message.